The Type W RotoClone, Arrangement D is designed to collect heavy concentrations of granular dust. The Arrangement D is equipped with an integral wet centrifugal precleaner, which removes a high percentage of the incoming dust from the airstream. The pressure loss in the we precleaner section is approximately twice the value of the inlet velocity pressure for an Arrangement A RotoClone of the same size. Collected dust and water are continuously discharged as a slurry through a single hopper drain.
The Type W, Arrangement D model is available in seven sizes from 1,000 to 15,000 CFM. Contact us for information on larger sizes.
CFM (Air Volume):
1,000-15,000
Efficiency %:
99.00
Grain Loading/cf:
1-2
Hours of Operation:
24/7
Material Characteristics:
Dry, Wet, Sticky, Corrosive, Oily, Fibrous, Ambient Air
Max Temperature:
400° F
Type of Collector:
Wet
Type N RotoClone
Type N RotoClone, Arrangement C, is designed to reduce manual removal of collected material. It is recommended for moderate and heavy dust loads and continuous service applications. This arrangement is frequently used for foundry sand handling applications; abrasive cleaning, buffing, and grinding; material handling; and dryer and process exhaust.
Steep sides in the hopper minimize material build-up, while the sludge ejector mechanism provides easy removal of collected material. The ejector assembly is designed for heavy-duty service and driven by a small geared motor. A slow chain speed, combined with a long steep ejector chute assures effective dewatering of the solid material as it is ejected. Scrubbing water is conserved and make-up water is reduced.
Arrangement C is available in 15 sizes, with maximum dimensions of 28'8" x 8'7" x 18'0".
Efficiency %:
99.00
Grain Loading/cf:
5-10
Hours of Operation:
24/7
Material Characteristics:
Dry, Wet, Sticky, Corrosive, Oily, Fibrous, Ambient Air
Type W RotoClone
Type N RotoClone